I bought a set of odometer gears from garagistics, they came in today. I promptly installed them per the instructions off their site.
Tried it out later and the odometer isn't working still. Any suggestions on what I am doing/did wrong here?
Out of the 3 old gears the smaller one and one larger one were broken. So I highly suspect that was the issue.
Took the seal bearing/ring off the small sprocket before putting the new one on.
Put them back in reverse order with the "spacer" as well.
The small sprocket is a tight fit on the rod, doesn't seem to go down far as is should? (still lines up with teeth on larger cog though)
Here is a short video of the cluster/install.
Tried it out later and the odometer isn't working still. Any suggestions on what I am doing/did wrong here?
Out of the 3 old gears the smaller one and one larger one were broken. So I highly suspect that was the issue.
Took the seal bearing/ring off the small sprocket before putting the new one on.
Put them back in reverse order with the "spacer" as well.
The small sprocket is a tight fit on the rod, doesn't seem to go down far as is should? (still lines up with teeth on larger cog though)
Here is a short video of the cluster/install.
Comment