I confirmed that we do not have an OBC system (side note, we have an analog clock).
I connected pin 85 of the relay directly the ground (at the strut tower). Doing that allowed the relay to switch when I turned the key to the run position. This seems to confirm that there is a bad connection somewhere between pin 85, the DME, and ground. Are there any likely suspects for this?
I connected pin 85 of the relay directly the ground (at the strut tower). Doing that allowed the relay to switch when I turned the key to the run position. This seems to confirm that there is a bad connection somewhere between pin 85, the DME, and ground. Are there any likely suspects for this?
Comment