Hi guys. My three screws were rusted and unfortunately I didn't do a spectacular job drilling them out so my plan is to use blue RTV to make a gasket and clamp the hose fitting piece to the throttle body, then after the RTV cures, use JB weld around the perimeter of the housing to hold it in place in lieu of the three screws. I know it's not a serviceable solution but then again neither is my throttle body in its current state anyway.
Any suggestions? The screws being rusty is pretty common so I'm trying to be resourceful and use what I have.
Here's a pic of my rebuild so far for those who like pictures
Any suggestions? The screws being rusty is pretty common so I'm trying to be resourceful and use what I have.
Here's a pic of my rebuild so far for those who like pictures
Comment