I am trying to replace my exhaust tips. The tips on there now are pretty rusty and stuck in there. They go inside the muffler, they do not sit on the outside like they should and were clamped on. I have drilled holes in each tip and put a screwdriver in there and pulled on it. I have also tried heating the muffler outlet still didn't work, any suggestions?
-
-
Try some wd40, but the muffler will smoke for a while when hot.
-
ive tried pb blasterComment
-
sawzall the current tips with some extra, then get tips big enough to slide over what is left. just a thoughtComment
-
thats probably the best idea, hopefully the new tips I have arent too long.Comment
-
Cut them if they are. Where in hopkington are you? Off 135?Originally posted by Jbpka06 View PostOriginally posted by cabriodster87Originally posted by KershawComment
-
the new tips are 2.25 in 3 inch out with a rolled tip. I think the 3 inch may be a little large but i like the rolled edge.
I am located right off 85 in Hopkinton, near the Milford/Holliston borderComment
-
Comment