Announcement

Collapse
No announcement yet.

Power Windows = Fubared.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Power Windows = Fubared.

    So i decided it would be a nice cheap mod to paint my door panels black. All was well with the car before this. I remove the 3 door panels fine then get to the back right to find the window switch harness is gone and spade connectors have been pressed on which have corodded heavlily. I have to rip half the spade connectors apart and end up gettting two permenately stuck on the window switch. I have an extra and throw it on there after putting in new spade connectors. Well i put all the door panels back on to find the power windows are dead. None of them are getting power anywhere.

    -So i troubleshoot the circuit breaker switch. It works fine, i even bridged the connection with a short wire just to make sure.
    -The fuse is not blown or blowing out
    -The hot lead on the circuit breaker switch is getting power and i can complete that circuit easily there but none of the switches are getting power

    any ideas?!!!
    HELP!

    Check Us out on Facebook
    Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
    Full Product Line Tuning
    OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread

    #2
    Ok....

    1. Power at the breaker... correct?
    2. Check for power at terminal 3 on the LHF and RHF window switches.

    Comment


      #3
      There was no power at terminal 3. So i wired a wire from the hot side of the breaker to terminal 3 and they all work now. :D

      Check Us out on Facebook
      Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
      Full Product Line Tuning
      OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread

      Comment


        #4
        Good times..... Still odd, as there is only wire between the breaker and terminal 3.....

        Comment

        Working...
        X