I'm quite baffle by the amount of carbon fiber hood and trunk lid that simply doesnt fit right if at all. I seen a ton that just stick out or short on the side. The question is..
WHY DO THEY COME OUT SO FUCKED UP? I can never figure it out? don't they use a functional hood as a mold, and shouldnt the mold come out the same as the template? I'm dying for a hood and trunk carbon fiber unit, but no way in hell can I deal with anything taht doesnt look like it fits perfectly.
I would look like someone hit my car and the repair job was poorly done rather than a carbon fiber upgrade.
someone shine some light on my ignorance.
WHY DO THEY COME OUT SO FUCKED UP? I can never figure it out? don't they use a functional hood as a mold, and shouldnt the mold come out the same as the template? I'm dying for a hood and trunk carbon fiber unit, but no way in hell can I deal with anything taht doesnt look like it fits perfectly.
I would look like someone hit my car and the repair job was poorly done rather than a carbon fiber upgrade.
someone shine some light on my ignorance.
Comment