If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hey guys, I read on www.bmwe30.net that you could put an O2 sensor from a 5.0 Mustang in the 6 cylinder cars.
Can I do this in a 4 cylinder car? Will it run right?
If it's an early 318, then I don't think it will work because the mustang uses the 3-wire O2 sensor and the M10 uses the 1-wire sensor. The 1-wire sensors are cheaper than the mustang 3-wire ones anyhow. You can regularly find them on eBay for $25 and I recently purchased one for $20.
Comment