Oil Tube to block - parts sequence help needed

[smcdermott326]

Can someone advise the exact order of placement/relationship for the Oil feed tube parts from the bottom of the intake to the block?
The Real OEM diagram doesn't show the position of each piece:
09 O-RING (2) - 11151714390

10 FLAT WASHER (2) 11151280937

11 COMPRESSION SPRING (1) 11151265346

12 PIPE (1) - 11151280938

Thanks,
Steve

[deansbimmer]

1: Put the lower O-ring in the block
2: Lay washer on the block over the lower O-ring
3: Insert spring onto lower portion of tube
4: Insert top O-ring onto top end of tube (or in the intake)
5: Insert sprung tube assembly into the lower end of the block
6: Insert O-ringed intake over the top of the tube, and angle towards the head and bolt it up.

Tip: Use two Zip Ties to compress the spring during installation. When installed and intake is secured, cut and remove the zip ties. You should have a leak free install if done properly.