I had the clutch, starter, shifter linkage, and control arms w/ bushings replaced.
I know it needs: new front bearings, lug bolts, rotors, and pads.
what should I do next?
Like i posted previously, it's a little jerky in 2nd and 3rd gear (i.e. when i lift off the gas in 2nd and 3rd, it jerksand when i gas it again, it sorta lurches again).
How can I make sure it runs solidly before I modify it?
thanks
I know it needs: new front bearings, lug bolts, rotors, and pads.
what should I do next?
Like i posted previously, it's a little jerky in 2nd and 3rd gear (i.e. when i lift off the gas in 2nd and 3rd, it jerksand when i gas it again, it sorta lurches again).
How can I make sure it runs solidly before I modify it?
thanks
Comment