2.7i question?

[Pat W]

how much power is made from doing this to an eta? im thinking of doing this....thanks in advance

[hotghias]

depends on what else you do while you're at it. upgraded exhaust? chip? extrude hone? i would expect a small gain in peak power over a comparably equipped "i", but more area under the curve, so to speak.

[Rob]

I just recently sold a 2.7i built from a super eta block, it was a nice little combination for the money. good low end grunt with more top end than any eta (obviously)

[Pat W]

if i were to use the i head tb and full exhaust...would i be able to use my jc chip? please give me some help

[Rob]

yes, you would be able to use that chip, it wont be perfectly tuned for the motor. I believe they actually have a chip for that setup though...

[Pat W]

with the 2.7i setup that i explained would my motor rev to 7k?

[Rob]

with the proper software I think so....

[Pat W]

nice anyone else on this fourm running a 2.7i?

[The Sly]

I am sure that there is a few boys out there with the 2.7i

it is a nice combination to do ...but expensive to do as a complete rebuilt...M50 swap is cheaper and better

[F|2eeSTy|e]

look for slammed_e30's car... It is a 2.7i