Sound Deadening other than Dynamat?
Collapse
X
-
Kenny, try this:
I used it in the 'vert, works well.Leave a comment:
-
I dont remember exactly. I know for the tape, 2 cans of spray glue and that stuff was about 75.00 or so.
Is about 1/4 inch thick at most. I had enough to do my whole floor all the way up under the dash. Under the whole back seat and inside the quarter panels. I didnt have enough to do the front doors. I will be getting a small roll in a few weeks.Leave a comment:
-
-
Leave a comment:
-
I used this...

I actually bought it from lowes. Not only does it cut down on road noise, it helps keep it warm when its cold and cold when its warm. :)Leave a comment:
-
George, why didnt you run the speaker wires, i assume the yellow ones, along the wire channels on the floor rails both left and right side? i am about to install sound deadening from raamaudio in my m3. just curious, chuckerLeave a comment:
-
Here ya go. http://www.r3vlimited.com/board/show...ighlight=edead
At the same time I did that, I installed some vinal seats that I slathered with an armorall jell. I mean I soaked the fuckers good. But in the hot sun, I started getting TONS of window haze. I don't know if it was the eDead or the armorall.
Here some pics:







Leave a comment:
-
I used a new product called "HookerSkin"
Got it from Vince, the guy from ShamWowLeave a comment:
-
Sound Deadening other than Dynamat?
I'm looking to buy some sheets of sound deadening, but don't want to pay Dynamat prices. Anyone know of a good place to buy a significant amount of it?Tags: None

Leave a comment: