If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Brake rotor spacers should be 12.5mm, I understand. EBI used to make them... and apparently, the ones they made were not very good at all. They're not hard to replicate though.
They arent exactly 12.5mm. It all comes down to the grade of aluminum that is used. I stepped up the last batch I made to a 7075 from 6061 as a few points in the spacer are thin and prone to breaking down. Cost a bit more, but I think its worth it.
Looks like I'm going to get the housings here in a bit once I'm done with my swap.
At that point I'll either look into E36 M3 stuff with the rotor spacer, or see how big my tax return is next year and do Massive stuff all the way around.
Need parts now? Need them cheap? steve@blunttech.com Chief Sales Officer, Midwest Division—Blunt Tech Industries
I would have to go pull out the schematics I drew up for them, and dont really feel like it. I might be making another batch if there are interested parties.
Comment