So I'm currently working on s52 swap project with 5 lug swap- typical e36 m3 fronts, 318ti rears. Everything is already bolted up and I just need to connect the ABS sensors. Here's the stock wires that I have: two red wires front left, two yellow wires front right, two green wires rear left, two white wires rear right. Rear ABS sensors have two wires, so I can just splice them in. Front e36 sensors have three wires. Which two wires do I splice into the stock harness?
-
-
Bump. Anyone? I searched and most say to color match the wires. But I have two same color wires for every sensor on stock harness -
I doubt the polarity matters.Comment
-
Ok, so connect black and brown wires from the ABS sensor to the two wires on stock harness and leave the yellow wire disconnected?Comment
Comment