B90 Tool worth it?

[Gooch]

It's definitely worth it to rent it, check out the NJ BMWCCA toolbox and shoot Ken an email.

[KenC]

i just use a slide hammer and some willpower to get them out

I used a 10lb slide hammer and it still dragged the nut accross the threads on the shaft.

[Gnarles]

I used the wheel bearing tool from harbor freight last month to do my wheel bearings and it only took a couple of hours to do both sides. Definitely worth the purchase.

[Julien]

i just use a slide hammer and some willpower to get them out

[FredK]

I've used it a few times. It does not have an attachment to pull the halfshaft into the hub, but the halfshaft should slip right in. Sometimes it takes a little coaxing, so you can place a piece of wood on the flange and tap it in with a hammer.

It makes the operation easy to perform while the trailing arm is still on the car.

[alpinewhite318i]

Has anyone used the B90 tool for the rear wheel bearing? Also does this tool have the attachment to pull the halfshaft into the hub?