If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm replacing my cables. The cables are routed through metal sleeves/tubes attached to the car. I'm tugging from the backside of the car, but these cables won't budge. Any ideas?
Douse them in PB Blaster, then put a set of Vise Grips on the metal barrel of the parking brake cable right where they enter the guide tubes above the rear subframe, then jerk them loose.
Comment