I don't even want to admit it but I did it. Was putting master cylinder back in and cross threaded a fitting slightly. From searching it looks like my option is to tap it/re-thread it and risk metal shavings or buy a new MC. It's a 25mm mc so I don't know where to get a cheap one. Is re-threading really an issue? Any other ideas?
-
'90 325is -
if anyone cares I had a local shop tap it.'90 325is -
good save, i'm surprised the line nut didn't get a little boogered upsigpicComment
-
It did. A little double 0 steel wool cleaned the boogers. Brass fittings into aluminum. Brass wins.
Sent from my SCH-I605 using Tapatalk'90 325isComment
Comment