Does anyone have the technical dimensions for the rear trailing arms? I need to check to see if they are square and I have no point of reference, usually the factory repair manual will have this information, but I can not find a full copy online.
-
1989 Cirrus Blau coupe Racing Dynamics wheels and a Volvo Spoiler. -
Without a custom built jig and the measurements it would have for new arms, the best way to tell if the trailing arms are bent is to put them on the car and check the alignment of the rear wheels.The car makes it possible, but the driver makes it happen.
Jim Levie, Huntsville, AL -
Well if the mount on the subframe is bent or which side or both side is bent.1989 Cirrus Blau coupe Racing Dynamics wheels and a Volvo Spoiler.Comment
-
Bends in the mounts for the trailing arm bushings are pretty obvious and have little effect on rear wheel alignments. A bent rear subframe is a different matter and may not be obvious.The car makes it possible, but the driver makes it happen.
Jim Levie, Huntsville, ALComment
-
old thread bump, was this ever solved?
Comment
Comment