good lord check out this control arm bushing!

[PiercedE30]

I'd be down for a set.

[xLibelle]

i'm guessing that you have to remove the block off the ctrl arm and rotate the lollipop against the threads internal to the mounting block, in order to make an adjustment?

[rs4pro3]

ya you just remove the 2 17mm bolts holding the block to the frame and spin it around to get the desired adjustment.

[cahomey]

and i thought i should worry about my pan.

[xLibelle]

if this was discussed before, sorry, i didnt see the thread.
ok. what kind of metal are you using? did you weld the eye to this threaded rod or is it one machined piece?
basicly, what have you put it through? how long ago installed and what does it look like now?
i think i would like a set

[rs4pro3]

I used a high quality rod end with the threaded part built in, it slides right on the control arm with some minor paint removal. The threaded block is aluminum. I've put the car threw some seriose mtn. drives, etc.... The car basically has a completly solid suspension, coil overs, etc..... They have been on the car about 4 months now and are holding up great. I'd recomend replacing the rod ends about every year or two, as grit and stuff can contaminate the bearings. But they are only about $18 each(if I sold these I'd include one extra set)

[xLibelle]

you should post a feeler if youre considering making these again. i'm in.

[lordofmpower]

I custom made them myself and have thought of making more.

I would be interested in a set!

[colombacho]

did this ever get done?

[PiercedE30]

no

[xLibelle]

did what ever get done, a batch? no

but i did get my order. they're tight!