If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I replaced the rotors and pads. I tightened the torx bolts for the caliper I tight as I could get them and there is some in/out play. It seems I am out of thread. Any ideas?? Will it tighted when the brakes are applied? Thanks boys!
If they are tight, that is as far as they go. The caliper will float, as in it is supposed to have some movement so when the brakes are applied, both pads get equal pressure on them:p
Originally posted by cabriodster87
"Honey? What color is this wire? Is it the same as that one? Are you sure? I don't believe it. OK, it works. Thank you sweetie."
If they are tight, that is as far as they go. The caliper will float, as in it is supposed to have some movement so when the brakes are applied, both pads get equal pressure on them:p
X2 :)
Will
RIP e30 (brilliantrot '91 325i) 11/17/06 Byebye: 8/21/07
Welcome e30 (brilliantrot '90 325is) 12/23/06
DaveCN = Old Man
My signature picture was taken by ME! Not by anyone else!
Originally posted by george graves
If people keep quoting me in their sig, I'm going to burn this motherfucker down.
Comment