and its still stiff. haha
heres the current situation. I bought the car, knowing that the brakes did not work, i was told by the owner that it was the booster and that did seem the case, brake was rock hard and didnt do anything.
changed
new/used brakebooster and MC, new pads new rotors.
first put on MC w/o bench bleedng and pumped the brake alot, brake went down pretty fast and didnt bleed at the wheels.
then was told that i needed to bench bleed it. i then took it off, bench bleed it correctly, put it on, brake is hard again. loosen bleeder screw, brake still hard, now fluid coming out. tried all wheels. tried taking bleeder valves off and using a pick to clean it out, still nothing, brake rock solid.
then followed the 2 lines from the MC to the abs pump(i blieve its ABS), loosend the 2 lines going threw, and bleed it there, fluid did come out, tightend screws, should be fine.
then loosened the 3 lines coming out of the abs pump, pressed brake, and it was solid with nothing coming out of the ABS pump.
is this where my problem is at? did pumping the brake earlier w/o benchbleeding put alot of air inot my system maybe? what should i try next?
thanks,
desprate andrew
heres the current situation. I bought the car, knowing that the brakes did not work, i was told by the owner that it was the booster and that did seem the case, brake was rock hard and didnt do anything.
changed
new/used brakebooster and MC, new pads new rotors.
first put on MC w/o bench bleedng and pumped the brake alot, brake went down pretty fast and didnt bleed at the wheels.
then was told that i needed to bench bleed it. i then took it off, bench bleed it correctly, put it on, brake is hard again. loosen bleeder screw, brake still hard, now fluid coming out. tried all wheels. tried taking bleeder valves off and using a pick to clean it out, still nothing, brake rock solid.
then followed the 2 lines from the MC to the abs pump(i blieve its ABS), loosend the 2 lines going threw, and bleed it there, fluid did come out, tightend screws, should be fine.
then loosened the 3 lines coming out of the abs pump, pressed brake, and it was solid with nothing coming out of the ABS pump.
is this where my problem is at? did pumping the brake earlier w/o benchbleeding put alot of air inot my system maybe? what should i try next?
thanks,
desprate andrew
Comment