If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have the e21 booster and the plastic fitting does not seem to want to got into the hole on the e21 booster, where the vacuume goes in. I am useing the one off the e30 booster. What do you guys use to make it work?
Thanks.
Originally posted by cabriodster87
"Honey? What color is this wire? Is it the same as that one? Are you sure? I don't believe it. OK, it works. Thank you sweetie."
I have the e21 booster and the plastic fitting does not seem to want to got into the hole on the e21 booster, where the vacuume goes in. I am useing the one off the e30 booster. What do you guys use to make it work?
Thanks.
I had no trouble, holes were the same, insert the rubber grommet first, lube the plastic fitting with wd40/crc and it should go.
Current:
BMW 320i 2d 2.0 m20 -88
BMW 325i Cabriolet 2.5 m50 -88
BMW 316i touring 1.6 m40 -90
BMW 320i 4d 2,2 m54 -01
Comment