Feeler idea

[Mr Deagle]

would anybody be interested in a custom dual master cylinder setup for an e30? No booster, just two tilton masters (one for front circut, one for rear) it would have full bias control through mecanical means.

It would probably be great for a m/s5x conversion

this is just asking if somebody would want such a thing


thats what it looks like

[DarkWing6]

everyone is going to ask it and i know i want to know soooooooo

how much?

[Mike325]

everyone is going to ask it and i know i want to know soooooooo

how much?

[asubimmer]

everyone is going to ask it and i know i want to know soooooooo

how much?

[trent]

I have been planning on making my own, simliar to my current setup.

[Mr Deagle]

when we sold them for the porsches, they were 600, note this is all cnc'd stuff

r3v might get a discount

I have been planning on making my own, simliar to my current setup.

and i think mine would just be a tad bit better quality then what one would diy

[PeaveyBassist]

Would the lines/adapters be included in the price to adapt them to the stock lines already in place?

Will

[Mr Deagle]

im not sure yet, i just have the master cylinder box right now, this is just an interest tester right now, if somebody would want one i would probably make some

most likely they would be included


what im talking about ^^

[Mike325]

That is a nice looking piece. So the end that is touching the desk goes on the firewall? Any more pics of it?

Thanks.

[trent]

and i think mine would just be a tad bit better quality then what one would diy

Of course for 600, it should be CNC. And yours is a very nice piece, however, mine is only "slighty" better than DIY. Hahaha.

[T.Dot_E30]

what are the benefits of going with this type of setup?

How would braking be with no booster?

[Mr Deagle]

yes, the end touching the desk goes on the firewall and bolts to the pedal box, i should have some pics of it installed in the car(not working yet) to show u guys about clearance

ask trent about braking without a booster

[AndrewBird]

Why make the whole thing one solid CNC'd piece? It would be so much cheaper to CNC each end out of flat stock and weld the center piece to the ends. A ton less machine time too.

[trent]

Why make the whole thing one solid CNC'd piece? It would be so much cheaper to CNC each end out of flat stock and weld the center piece to the ends. A ton less machine time too.

Why do you think I built mine the way I did?

[trent]

ask trent about braking without a booster

So, first you slam me, then want me to help you sell your product?

Right.