If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
ok im trying to change my front brakes and i freaken stripped out the bolt that holds on the caliper then i drilled it and still not coming out what should i do i really dont want to change the wheel bearing hub. any suggestions?:(
Get a torch and heat it up. Use an ez-out afterwards. I bet you the PO used loctite when he re-installed it instead of getting a new bolt, like he should have done.
Help!! Stripped bolt!
Comment