Rear control arm camber/toe "tabs"

[Cracker Red]

Is there any interest in a few of these sets? I need a set for my 318ti project, but thought we might be able to put a few people together and have some tabs made which would save quite a bit of $$ over paying $150 something for them.

Let me know if there is any interest. I can draw something up quick and get a quote, but if no one wants them I might as well just buy them off the shelf (have to make quantity to cut the cost down)

TAftonomos@gmail.com

[Cracker Red]

Bumping this up, looking at making a bunch of these end of this month. I can supply them with or without the eccentric bolts as well (but just as easy for you all to get them)

[NC325iC]

dudes selling them on e30tech 150 for all of them with hardware, dont be cheap and make knockoffs, thats not alot of money

[Cracker Red]

dudes selling them on e30tech 150 for all of them with hardware, dont be cheap and make knockoffs, thats not alot of money

Please tell me how making 8 brackets with a mill is being a "knock off". If I can make them on a bridgeport (or other mill) and save $100+, and offer it to other enthusiasts at the same time.....but thats fine. I'll make a set, save the coin, and off I go. Just as easy to set the machine up to make 50 of them as it is 8, which is why I posted it.

I don't think the "guy" on e30tech is the originator of doing this either....