Lowing the rear....more

[Fomocogogo]

I just installed suspension techniqe lowering springs. The shocks are still OEM for the time being until i get some more money to order billy sports. My question is how do i lower the rear even more. Currently the front looks great, very low, no tire gap. The rear on the underhand could use another 1" drop. Any ideas? Don't say cut coils.

Thanks in advance.

[jlevie]

You can get a few millimeters out of the rear by eliminating the spring pads. Without different springs that is all you can do.

[mazdarati]

You can get a few millimeters out of the rear by eliminating the spring pads. Without different springs that is all you can do.

this! but it wont gain an inch drop.

[bear]

Don't say cut coils.

Thanks in advance.

fine, then put a jack under the car and set it for an inch below the jack pad then heat the coil with a torch and then when the the car lowers down and touches the jack your done, nevermind don't do that either, stick a fat chick in the trunk

[ak-]

If you remove the spring pads, will you ship them to me please lol?
I need some.

<3

[xwill112x]

buy ie3 rears