bc coilover owners, need more low

[simplyclean325i]

I am really good friends with all the guys at BC. Take out the adjuster and all the rubber pieces if you want it to go as low as possible. I run a 120mm spring in the back. Here is a picture after I raised it up about an inch. Car looks completely different these days but this was right when I dumped it on BCs. They have tons of springs in stock and can send you whatever you want for a small fee.

I actually had to cut out the factory metal bump stop holders in the rear because it was so low. I put an S52 in it so I had to raise it up. Sorry for the cell phone pictures.

i want to keep the adjusters in to be able to play with the height. i know guys add smaller springs in there and was wondering what they went with. so i can get in contact with bc and ask for new rear springs that are shorter and stiffer? they have horrible customer service everytime i've tried.

[einstein57]

Thats odd cause 5" 650 GC springs with no adjusters don't go that low. Do BCs have dead coils?

http://www.r3vlimited.com/board/showpost.php?p=2736233&postcount=100

[JTe30]

When I had it super slammed it was with the 120 mm springs with no adjuster and about 10mm of preload. I added the adjuster in there with only the bottom lock to raise it up to that height. I can't find any pictures of it slammed all the way down. It only stayed there for about a week and then the S52 went in. The 120mm they have are kind of a high spring rate, I think 12k so it will ride a little stiff.

[jaywood]

That's pretty daaamn low JT. Pics with the 120mm springs?

[JTe30]

I am really good friends with all the guys at BC. Take out the adjuster and all the rubber pieces if you want it to go as low as possible. I run a 120mm spring in the back. Here is a picture after I raised it up about an inch. Car looks completely different these days but this was right when I dumped it on BCs. They have tons of springs in stock and can send you whatever you want for a small fee.

I actually had to cut out the factory metal bump stop holders in the rear because it was so low. I put an S52 in it so I had to raise it up. Sorry for the cell phone pictures.

[einstein57]

What's the I.D.?

[jaywood]

It rubs, but you want to go lower?

[simplyclean325i]

Have you taken out the adjusters yet?

yeah, fenders are rolled and it rubbed a little and i would still like to be able to play with the height.

[jaywood]

Have you taken out the adjusters yet?

[simplyclean325i]

rears are dropped all the way. what springs should i go with in the rear for it to go lower? i need a good spring rate too. into stance.