z3 rack ?

[bastianshaw]

can I just reuse my old hoses?
if no why not?

[Victell]

Yes. One hose doesnt line up right at the rack but you can bend it to fit.

Bend slow and incrementally.

[bastianshaw]

Yes. One hose doesnt line up right at the rack but you can bend it to fit.

Bend slow and incrementally.

is it the HP hose and should I remove it to bend it?

[Victell]

is it the HP hose and should I remove it to bend it?

Not sure if its the pressure or return line, but you dont have to remove it. Put your new rack in first then see how it doesnt line up.

[bastianshaw]

Not sure if its the pressure or return line, but you dont have to remove it. Put your new rack in first then see how it doesnt line up.

I take it you ve done this?

[Victell]

twice. but both on 91s so i didnt have to deal with the column shaft adaptation.

[bastianshaw]

but you used the old ps hoses and everything was cool?
how long did the bending take?

[Victell]

I told you in my first post that you could use your existing lines. The bending shouldnt take longer than 20 minutes.

[bastianshaw]

I told you in my first post that you could use your existing lines. The bending shouldnt take longer than 20 minutes.

ok ok thank you lol