front clunk/popping noise

[immajackuup]

things I have replace in pairs,inner/outer tie rod,cab poly bushing akg,swaybar link/bushing,lower control arm. noise was already there before I replace whole front end with new parts.

[nrubenstein]

Uh, when does it clunk? Moving, not moving? From what you've said, I'd look at the things you haven't replaced. If its when stopped, I'd look at the subframe/steering rack. If its when moving, look at the engine mounts as well.

[immajackuup]

clunk happen on bumpy road and very noticeable when turning left or right. I also can feel the clunk near my pedal.

[nrubenstein]

Engine/trans mounts are the first thing I would look at. Along with, you know, making sure that the subframe and steering rack are torqued in.

[immajackuup]

if your oil pan sit about half a inch away from your skid plate does that mean motor mount is bad? also crossmember and rack bolt is tight on.

[nrubenstein]

if your oil pan sit about half a inch away from your skid plate does that mean motor mount is bad? also crossmember and rack bolt is tight on.

If your engine mounts are more than 5 years old, assume they are bad and replace them.

[immajackuup]

If your engine mounts are more than 5 years old, assume they are bad and replace them.

ok

[immajackuup]

should i get metal bushing or poly?

[e46s54dr]

Mine did the exact same thing. Especially when I had the wheels turnt and braked. It was the strut bearings taking a dump in my case.

[immajackuup]

Mine did the exact same thing. Especially when I had the wheels turnt and braked. It was the strut bearings taking a dump in my case.

this happen previous with my old suspension as right now I have full coilover set. can poly cab bushing make popping noise?

[beedeezy]

My left CAB pops, just replaced with solid poly. Not sure if this is normal, only been 2 days.

[immajackuup]

turn out poly bushing needed lots of lube. green grease ftw!!!