Steering Pulling to Direction of Last Turn
Collapse
X
-
It's also something to look for when going to camber plates or changing anything with the spring hat/bushing/mount setup. I fibbed a bit when I said I made the same mistake. My issue was actually an aftermarket camber plate with a poorly designed spherical bearing that required extra clearance via a spacer equal to 2-3 of the factory washers. I just simplified my description because I knew it was the same symptoms as what would happen if you leave out the washer in the factory setup.
So, in short, always check the clearance between those parts when reassembling them, especially when aftermarket parts are involved.Leave a comment:
-
-
-
Yes, I have new mounts on (which include new bearings). The old ones were falling apart. Thanks.
Edit: Glad I am not the only one who has forgotten to put this washer back in!Leave a comment:
-
I had the same issue, and as others said, the spring hat was rubbing on the strut mount due to the lack of the washer. I spaced it up, and the problem went away. The steering became much lighter, too.Leave a comment:
-
This is a good idea, they should be $30ish each iirc, the one in my video was replaced as I ordered it initially thinking that was my problem and my steering has been awesome since!Leave a comment:
-
When replacing all of those suspension parts, did you also replace the upper strut bearings? If not, get them before you tear down the struts for the missing washers.Leave a comment:
-
Good luck! Have a buddy to help you! Never underestimate a second pair of eyes.Leave a comment:
-
Thank you good sir. Now comes the challenge of fixing this in the university parking deck with 2 jack stands, a widowmaker and limited hand tools.Leave a comment:
-
Thank you!
I did not replace mine. They are supposedly one time use though. The nuts just have "locking material" (nylon?) in them from what I can tell. Maybe someone else can chime in on this but mine haven't moved and are fine.Leave a comment:
-
Alright thanks. One more question, if I JUST replaced all of the lock nuts (i.e. top strut mount nuts, ball joint nuts, tie rod nuts, and shock nuts, will I have to get all new ones again or can I get away with reusing them, maybe with some loctite?
BTW nice ride, we have the same color, year and model!Leave a comment:
-
You should be fine man, I drove for a week or two (I only really work on my cars weekends) and it was all good.
Yes although not as immediately important, you want the #4 to make sure the top nut doesn't move!Leave a comment:
-
Awesome, thanks. I actually noticed movement like that when I was testing it and I noticed that terrible noise once I drove it. I must have just totally spaced while putting the struts back together cause I forgot #4 as well, though that isn't nearly as important. Did you see anything screwed up when you fixed it or did you just throw the washer on and be done with it?Leave a comment:
-
Those washers are required... this was what my car was doing:
This is the washer #8... this pic is from an M3 realoem.com but it should be similar if not the same:
Leave a comment:

Leave a comment: