Rear Koni Adjustables

[DRTSRFR]

Did you remove the bumpstop?

[jlevie]

You can see the instructions on Koni's site. With those spring rates you might try starting at about 2 turns from full soft.

550 front and 650 rear strikes me as an awul lot of front spring as compared to the rears. Usually you'd want the front springs to be about 55-60% of the rears unless the engine has been swapped out with one a lot heavier than stock.

[IronFreak]

So I picked up a new set up rear adjustables from another member on here. When I opened the box there where direction for adjusting them, but not in English. Could someone give me a rundown?

I heard that you have to compress them completely then turn, but I did that and it just spins. I want to make sure I have both back shocks set the same before I put them on the car.

Also, if someone could give me a good baseline to start at as far as adjustment. I know to each his own but a little input wouldn't hurt. I will be running Eibach coilovers 550 fronts, 650 rears.

Some pictures of the shocks




Thanks,