If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
H&r race without toe/camber kit-how severe is tire wear?
To add to the mix, here are my 200 treadwear ZII tires supported by H&R race with about 3000 miles so far. I don't have camber plates or anything else that effects ride height or alignment besides CA offset bushings.
And as always, proper inflation and driving hard can even out the wear quite a bit. Here are the outside of my fronts
I actually could use a few more PSI in the front. Whoops :\
perfect man, thanks for posting - thats all Im planning on running is the offset CA bushings since theyre already installed, doesnt looks like the effects are too bad over 3k miles...Ill definitely be getting an alignment to make sure the front to is squared away.
So that wear was done on the front of your car? Was that the inside or the outside of the tire?
My guess would be that your toe is off. When was the last time it was aligned? You'd have to run with massive camber for a LONG time to see uneven wear like that. On the other hand, if your toe were even a little bit off you could scrub those tires down pretty quick.
Yes that wear was done on the front. Wear is on the inside and it has been a while since i've had an alignment so you're probably right about the toe
Comment