ST rear sway bar link, how to assemble?

[peller]

Hey guys. I'm having trouble understanding the shit diagram suspension techniques included to show how to assemble the rear sway bar links, can anybody tell me if this is correct? The pen represents teh sway bar and the screw driver the trailing arm. yea, the bottom bolt should be through the U bracket but i was lazy before snapping the photo.

Thank you!!

[1990m3]

that looks correct to me. Make sure to weld the reinforcements on your trailing arms otherwise they will break. Ask me how I know...

[ddavidv]

Ditto. Just so you know more than one person says you are right. ;)

[einstein57]

i had mine originaly set up like that but they sit at a heavy angle under load like / instead of | straight like the factory ones. i switced it to the other side and it squats to the other side but not as severily. No difference in installation ease or handling. not 100% sure cause i installed ecentric bushings and urethane subframe bushings. But i think the bolts are too short cause the don't allow ypu to tighten the nuts down to the nylon.

[vivalegreg]

can you all show us the setups installed on your cars?