This springs is good?

[TexasE30]

I'm doing whatever I can to drop my car. I'm not going to cut my springs thought I did think about it. Those spring will drop my car by 2 inches in front/rear. Its good enough for me. I already have bilsetin shocks in rear but not front.

I would run them until I have enough money for the sets (springs/shocks). Opinions?

http://www.slickcar.com/productdetails.asp?ProductID=7350

Those springs re going on this car.
on slant ground on empty tank but its in 4x4 status..:(

[Liam]

Says they are TUV approved but I've never heard of them so I really can't say. Ask for a spec sheet on them and post it here (if they send you one). Be good to know if they are tempered or cold wound as well.

This is important: Do Not lower the car without shorter shocks and strut inserts if you do it can really fuck shit up.

[Adrian_Visser]

Thats not true at all dude. Running stock shocks/ struts will cause your shocks to wear out way quicker and because they will be running at a lower than normal height the valving won't be quite right ( shocks are designed to provide their correct amount of dampening at a certain position, if they ride lower the dampening won't be the same). Running your stock shocks won't hurt anything they will just wear out faster.

[TexasE30]

I already have bilstein shocks in rear. So, I think I will be fine with rear but I know I need to change front because its stock. I guess I will order those springs tomorrow and test it out. :)