Looking to mount Borbet Type S wheels on a H&R lowered 318is. 16x9 et15 w/ 205/45 rubber, 3mm spacers in the front. Will I need to roll any of the fenders to prevent rubbing? Should I go with a different tire size (without looking dumb)?
Announcement
Collapse
No announcement yet.
The official "What is this wheel?" thread.
Collapse
This is a sticky topic.
X
X
-
Originally posted by mdlax30 View PostLooking to mount Borbet Type S wheels on a H&R lowered 318is. 16x9 et15 w/ 205/45 rubber, 3mm spacers in the front. Will I need to roll any of the fenders to prevent rubbing? Should I go with a different tire size (without looking dumb)?
205/45 of 16x9 is already very undersized rubber with some real stretch and would look goofy.
you will need to roll the fenders.
Also I looked around the internet for 235/40/16 and all I found were these tires
235/40/16 is much better fitment. Too bad they are hard to find
It should be the right amount of meat on the bone especially width wise[/SIGPIC]
Comment
-
Originally posted by E30Brad View PostAnyone try these Corsa GT Steelies yet? They look like they might clear the calipers in the front, but F@#$ if i know. I'm not trying to space the hell out of steelies again. Thanks. 16x8 5.00" back spacing 4x100 in photos.
steelies look damn good but not worth the heft IMO
Comment
-
ID please? RS? RM? RZ? I'm a bit confused.
17". 2" lip in the back, 1" in the front.
Back: https://imgur.com/DaNAOkh
Front: https://imgur.com/Aqre0Ic
Thanks, fellas.
Comment
-
Originally posted by badguise View PostID please? RS? RM? RZ? I'm a bit confused.
17". 2" lip in the back, 1" in the front.
Back: https://imgur.com/DaNAOkh
Front: https://imgur.com/Aqre0Ic
Thanks, fellas.
Comment
-
Originally posted by badguise View PostID please? RS? RM? RZ? I'm a bit confused.
17". 2" lip in the back, 1" in the front.
Back: https://imgur.com/DaNAOkh
Front: https://imgur.com/Aqre0Ic
Thanks, fellas.Byron
Leichtbau
Comment
Comment