If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MASSIVE: Thanks bro, im pretty much done modding it.
BeemerBuyer: Thank you, Im trying to figure out a good size spacer in the rear because I dont feel like rubbing,
SupaDave: I beg to differ, your car looks amazing with the rims. You can use a bit lower in the front though. As for suspension, Im running Eurostops D2 coil overs. My car used to be much lower but I raised it due to bullshit SoCal roads.
I can see half the price of a set of true BBS RS003's with 3" lips, but take the ESM Borbet A knock offs. With tires they still run you $1,500. I'm eyeing Vlad's setup of true, 16x9 all around w/fresh tires for $1,700 + shipping. C'mon. ESM? Never for the Borbet A's.
And I have to agree that the newer wheels don't look quite the same. Not bad by any means, and I'd definately rock a setup, but not at the price their listed at. Also, which I fully understand.
Looks good. Not for me particularly.
And on the Adapter front? Pfft. Nothing at all wrong with Adapters.
- They are one-piece pretending to be three-piece. Fake bolt heads.
- 9" width only makes sense on a racecar with at least 245 tires unless all you want to achieve is BLING.
- Could the offset of these wheels be at least correct to fit proper size tires? Looks like most people fit undersize rubber just to be able to squeeze them under the rear fenders.
Comment