Question on possible rims I might buy

[Beastolizer]

Been wanting to upgrade from my stock weaves for some time now and have been looking around and found a wheel for a great price that I want.

here is a link to the wheel:
http://cgi.ebay.com/ebaymotors/16-7-...ht_4340wt_1165

My question is, they make that same wheel in a 16x8 rather than 16x7, but the 16x8 has an offset of 0, and the 16x7 has an offset of 25. So would the 0 offset look goofy or would it be fine, and would I need my fenders rolled?

thanks,
-parker

[Van Westervelt]

Looking goofy is subjective. So thats really up to you. And yes you will have to roll or cut the rears to fit that size wheel, especially with an appropriate sized tire.

Furthermore, there is an entire thread for these questions, post there. And I can promise that this exact question about size and offset fitment has been asked in it many times.

Its right up top under the 'new thread' button in this very section.

http://r3vlimited.com/board/showthread.php?t=83125

[Beastolizer]

Looking goofy is subjective. So thats really up to you. And yes you will have to roll or cut the rears to fit that size wheel, especially with an appropriate sized tire.

Furthermore, there is an entire thread for these questions, post there. And I can promise that this exact question about size and offset fitment has been asked in it many times.

Its right up top under the 'new thread' button in this very section.

http://r3vlimited.com/board/showthread.php?t=83125

thanks man.