What wheel spec needed to run WIDE tires

[Jean]

To run something like 275/35/15 what wheel spec should I be looking for?

Width/backspacing/offset?

Thanks

[8380 Labs]

that's gonna be pretty tough without some fender work.

9" - 9.5" wide.

hard roll on the fenders.

offset somewhere around et25, but i think you'd still have some clearance issues.

this would be for the rear, no hope for that up front on anything resembling stock body panels.

[Jean]

Yeah, fenders will have to be cut/boxed that's fine. I am more concerned with clearing the INNER area.

[8380 Labs]

9.5 in the rear will clear with et20 for sure.

[z31maniac]

In the front you have to be in the ET0 range so the tire will clear the strut, IIRC. On a 15x9 that is.

[nrubenstein]

If you're going to cut up the fender, go big. 10-11" wide is the trick.

[Jean]

Any off the shelf wheels you can suggest in the correct config?