16x9 ET0 will it work

[e30zaz]

Hey guys I did a search but didnt find what I was looking for. Will 16x9 et0 work in the front and the back or should I go et0 in the back and et15 in the front? I am planning on rolling fenders. Thanks.

[E30_Pare]

Et 0 rear should work with a roll & stretch. The front would be hella poke at +0. You'd need some camber, stretch, & roll for sure. +15 should be a bit more manageable, but unless your uber slammed you shouldnt have to much trouble.

[e30zaz]

I do want a little poke. You think if I run a 5 or 10mm spacer it would be ok? Anybody have any pics of a 16x9 et10 or et5 in the front?

[CW325]

Running a spacer would make the offset lower so they would poke out even more. et0 with a 5mm spacer would be et-5

[e30trooper]

17x8.5 ET -4






mexi poke brah

[e30zaz]

I would use the spacer on the et15 not the et0 in the front. I think I'm gonna go et0 in the rear no spacer. Tryin to see what an et10 or an et5 would look like in the front

[grippymonkey]

http://www.r3vlimited.com/board/showthread.php?t=254271

you must of not done a ton of research cause this thread was recently made about 15x9 +0 which is the same fitment...

it can pretty easily work... it works better in the rear. The front pokes a little with stock camber (aka stock strut mounts).