If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I was only thinking of fender rolling for the back it's hard to tell be the pic, but my street is downhill toward passenger side. So right now my passenger side rear bottle cap has about a 1/4 inch or tire tuck.
I love that people ask stupid questions so I dont have.
Anyone know how much room you should have between inside tire and strut housing?
[ATTACH]69844[/ATTACH]
Any room is ok as long as it clears. 2 or 3 mm would be nice.
I'm have 225/50 falkens on mine and they have clearance but are known to run narrow. I think a "wide" 225 would prob contact the strut without a spacer.
So I have a finger tip between tire and rear fender lip. Hope it's enough until the weekend.
The issue is with the inside contacting the front strut housing. I think you are right regarding the brand of 225 that will fit. I think the wheel itself has at least 4mm clearance. there should not be an issue with contacting the fenders.
Comment