Opinions: Keskin KT1 Classics

[vt.bimmer]

Has anyone had these on their e30 or have any pics of them on one?
Im ordering wheels soon and Im 90% sure these are what I want.
Im going with 16x7.5 et20 on all 4 corners and hoping a 225/45/16 will fit without problems.
Pics, opinions, advice are all welcome.

[KangamangusDriver]

Here Ya go Green Mountainer:



Keskin KT1 9x16 215/40

[Dave]

Has anyone had these on their e30 or have any pics of them on one?
Im ordering wheels soon and Im 90% sure these are what I want.
Im going with 16x7.5 et20 on all 4 corners and hoping a 225/45/16 will fit without problems.
Pics, opinions, advice are all welcome.

I have always liked those wheels. As OZ Futuras are basically unobtanium, those are a nice substitute.

[vt.bimmer]

Here Ya go Green Mountainer:



Keskin KT1 9x16 215/40

Holy shit! Those look real good. Sealed the deal except now Im up in the air about the width. Those 16x9's look like they fit perfect. The only reason I was going with 7.5 is so I dont have to run a spacer or roll the fenders. The suspension is IE stage 3. Confused now.
Thanks for the pic!

[Dave]

I'd go with 7.5. But that's just me.

[Erick]

I have always liked those wheels. As OZ Futuras are basically unobtanium, those are a nice substitute.

I agree. I would definetly rock those rims.

[Brew]

Holy shit! Those look real good. Sealed the deal except now Im up in the air about the width. Those 16x9's look like they fit perfect. The only reason I was going with 7.5 is so I dont have to run a spacer or roll the fenders. The suspension is IE stage 3. Confused now.
Thanks for the pic!

You'll still have to roll your fenders with the 7.5s because of that low offest, but yeah- they will look fucking sick.

But IMO 17's would look better.

[vt.bimmer]

You'll still have to roll your fenders with the 7.5s because of that low offest, but yeah- they will look fucking sick.

Really? Ive been calculating other peoples setups and it seems that a 7.5 with 20 offset would fit perfect without rolling the fenders. Anyone care to chime in on this? I suppose the suspension setup would make a difference also?

[Erick]

With that offset and width, you might come close to rubbing... depending on tire size you might even have some rub. 205s would probably be fine, 225s are questionable.

[Dave]

When I had the Throwing stars that were 16x7.5 with a similr offset, there was rubbing up front.

It was a convertible on H&R Race springs.

[Erick]

Tire size?

[vt.bimmer]

Well I would really like the Hankook 225/45/16 R-S2's
Looks like the fenders need to be rolled then.

[Erick]

Such a shame.... :) Cant wait to see it!

[vt.bimmer]

Such a shame.... :) Cant wait to see it!

Hahaha, hope your not a Bronzit hater

[Erick]

I set my parts car on fire once. I also had a picture where I carved "just say no to bronzit" on the quarter panel, but my hard drive took a shit.

- Erick