Having 8" rims machined

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • xLibelle
    R3VLimited
    • Aug 2004
    • 2673

    #1

    Having 8" rims machined

    I hate these kinds of threads but i just had to do it because i want this to be right.

    This reguards the Slipstream GB and we are trying to decide on an offset.
    I hope someone with 8" experience could please help!!

    (Suggestions start near the end of the thread, if that link doesnt work right)


    Its a question if et20 will actually be enough to not have tires, 225 or 245, rub on the strut. I suggested that maybe et15 would be enough to be positive it will not happen. TIA!
  • Mystikal
    Moderator
    Wheel Fitment Expert
    • Nov 2003
    • 9602

    #2
    I spoke with 2002maniac about this.

    I know for a fact 16x8.5" ET17 wheels will fit 245's. These wheels have 3mm more room on the inside, but then again tire width is still almost a constant.

    I'd wager that they will fit fine. Worst case scenario, 3mm spacers up front. I don't think it's worth it to make them ET15, because then everyone will have fender clearance issues.

    Comment

    Working...