would these fit?

[neogenetik]

these are from a gsr

http://www.imagestation.com/picture/sraid110/p5416db6b2d70d8a2125129e9b39ebb5b/f9153ed7.jpg

http://www.imagestation.com/picture/sraid135/p39d2d43cb4847e6cdc2e0cc121c9f82c/f7662cd0.jpg

i have a 89 325ic

[Jand3rson]

They are Honda fitment, they will fit with spacers.

Those are pretty sick looking wheels. :up:

[neogenetik]

Hey

what fitment are honda wheels
and what mm spacers would i need and how much longer the lug bolts would be?
and a place where i could get some
thanks

[Jand3rson]

Re: Hey

what fitment are honda wheels
and what mm spacers would i need and how much longer the lug bolts would be?
and a place where i could get some
thanks

Well, Honda wheels are a front-wheel drive offset, whereas BMW wheels are a rear-wheel drive offset.

I'm not sure what size spacers you would need, but there are a lot of places you can get them, I would reccomend Tirerack.com. As far as the lug bolts, you would just need to make sure that you get long enough ones to be able to clear the spacers and get far enough into the hub. Wherever you end up getting spacers from, I'm sure that they will have the length you will need for your application.

[neogenetik]

he

i would say the wheels would be ET 40-42 since there honda

so suggestion for spacer size?

[///M Powered]

i'd suggest 10- 15mm just to be safe







and because i love a wide looking stance :P

[318daily]

wow. they do look nice. probably because SSR comps are the coolest.

they would probably fit after spending $200 in spacers, lug bolts, and hub centering rings.

[brodee]

I just want to say Thanks to Josh for helping this guy out and answering his question in a helpful way. The board seems to be a little more polite lately and it makes it nicer to come on and read the posts when people are helpful instead of flaming for flamings sake.

[Ryan Stewart]

Being said, guys try to put stuff where it belongs. There are more forums than general discussion and Community.

[Jand3rson]

I just want to say Thanks to Josh for helping this guy out and answering his question in a helpful way. The board seems to be a little more polite lately and it makes it nicer to come on and read the posts when people are helpful instead of flaming for flamings sake.

I do what I can. :D

I too was starting to get pretty sick of every new guy getting flamed to death when they asked a "newbie" kind of question, and I know I did it sometimes, too.
People that have been here for a long time tend to forget that they were once new to E30's as well.

[Mystikal]

Re: he

i would say the wheels would be ET 40-42 since there honda

so suggestion for spacer size?

15mm. Hubcentric.