What tools have you needed

[Unearth078]

basically a thread of WHAT YOU NEED to complete your e30 tool box

horror story's of previous owners maintenance also allowed

[RobE30]

REALLY long extension w/ a wobble and a swivel (to reach the top bellhousing bolt) a "modified" 30mm deep socket (to change the output shaft seal on trans). A welder is nice too;)

[e30-RTN]

+1 on the thin wall, deep well, 32MM socket.

[Turf1600]

hammer

[RobE30]

+1 on the thin wall, deep well, 32MM socket.

It's a 32mm for the output shaft seal? It's been a LONG time since I did mine. My bad

[devonjordan]

Duct Tape, zip ties, that should cover it...

[pawi30]

if it moves and it shouldnt used duct tape
if it doesnt move and it should use wd40

[TexasTerp]

beer, lots of beer

[newman]

DEF a grinding wheel:

[Unearth078]

lol the picture newman posted is intense.

i thought that tool combo was my lil secret rob e30. dont forget the inverted torx to actually get that bolt!

[erik325i]

There's nothing I need anymore, but every week Snap-on, Mac, and Matco stop by and I always end up with new tools.

Erik

[e30slut]

e30 = rust
rust = welder

[Japandrew73]

Combination Pliers

3 Spanners

[Axxe]

Visegrip, BFH, grinder.

[Unearth078]

erik, i can still only afford craftsman... must be nice lol. at least those shits still have a good warranty backing.