testing crank position sensor

[iwantspeed]

just trying to test the cps sensor and not sure if I did it right

which terminals are you suppose test
and is the value suppose to be 540ohms?

[evil_twin]

TESTING PULSE SENSOR

Disconnect the electrical connector. Using an ohmmeter, check the resistance between terminal 1 (yellow wire) and terminal 2 (black wire) on the sensor side end of the connector. If the resistance is not approximately 520 ±5 ohms, the sensor is faulty and should be replaced. Remove the sensor mounting bolt using a 5 mm hex wrench. When the sensor is installed, the distance between the sensor tip and the toothed wheel should be 1.0 ±0.3 mm (0.04 ±0.01 in.). Tighten the sensor mounting screw to 7 ±1 Nm (62 ±9 in.lb.) . Be careful not to overtighten the mounting screw. Be sure the wiring is correctly routed through the protective covering.

-Taken from Alldata