So a few months back my wiper arms got stuck up while on the eway. Before I could get off the eway to unwedge them the motor had started smoking so I knew the motor was done. So I bought a reman one. After a week of that one on I didn't put the motor cover on and the wipers would get stuck half way so I just figured water got in the motor and would make it lock at a certain spot. So I disconnected the linkage and activated the motor and it would lock with no linkage. So I got another one.
So I replaced it again and after a week its doing it in the same spot again. Any ideas or suggestions on wtf else it could be?
So I replaced it again and after a week its doing it in the same spot again. Any ideas or suggestions on wtf else it could be?
Comment