Steering wheel spacers

[jaywood]

This p/n 32311120260

Did anyone "make their own" by just using washers stacked up? Or does that not work too well?

Do I need 2 or 1 for an airbag car getting swapped with a nonairbag (sparco) wheel?

Thanks!

And yes I did search, nothing was perfectly clear so I just want to make sure before I order.

If this is the wrong section for this thread, please feel free to move it. I wasn't sure where to put this thread.

[blefevre]

One spacer.

I have heard people that used washers but I have no experience.

[Ian Bowers]

You just need to order a single spacer. Your car already has one. It goes Spacer - Wheel - Spacer - nut. Also, make sure you pull out the white plastic pin with springs on it when you do the wheel swap.

Washers would rattle around and annoy the fucking shit outta me.

[jaywood]

Okay. Thanks guys!

[jaywood]

Does anyone have any measurements on the spacer?

I might be able to make it on my lathe...

[whterice]

I just used brass oil plug crush washers

[dkbmxer002]

when i went from air bag to non air bag i put in a few washers from home depot, worked fine.

[jaywood]

when i went from air bag to non air bag i put in a few washers from home depot, worked fine.

I think that's what I'll do too.

Thanks guys.