Official Fabrication & Welding Porn Photo Thread

[Eurotrash727]

Good lord some of the stuff in this thread is mind blowing.

[TurboJake]

Oh, and this is what happens when a 3/4" endmill spinning at 14,000 RPM hits solid aluminum at 120 inches per minute. Took about 1/2 a second to do that and sounded like a train horn. Would have kept going had I not stopped it.

Just a hoggin that right out huh. Bet that fucker was LOUD.

[e30shmobberr]

ive gone through 4 years of metal shop at my hs, and was hired full time ofr 2 years straight out of hs as a welder fabricator for a performance racing shop.

lets just say this is my favorite thread..

[scottinAZ]

Oh, and this is what happens when a 3/4" endmill spinning at 14,000 RPM hits solid aluminum at 120 inches per minute. Took about 1/2 a second to do that and sounded like a train horn. Would have kept going had I not stopped it.

Ummmm, I think I see some chatter marks there.... :D


Damn, just Damn

[evandael]

ive gone through 4 years of metal shop at my hs, and was hired full time ofr 2 years straight out of hs as a welder fabricator for a performance racing shop.

lets just say this is my favorite thread..

i'm pretty jealous.

[willworkfore30s]

This thread deserves a bump

[jaywood]

This thread deserves a bump

Bump!!

[lambo]

Oh, and this is what happens when a endmill spinning at 14,000 RPM hits solid aluminum at per minute. Took about 1/2 a second to do that and sounded like a train horn. Would have kept going had I not stopped it.

I'll have to take a picture of the cluster-fuck in our shop...

[lambo]

I'll have to take a picture of the cluster-fuck in our shop...

lololol

[emerson.]

Grinded down the fins and mount area and welded in the holes.. then hit it with some buffing pads.


Trans mounts outta UHMW







intake manifold project I'm working on


Fun little project i did


Shift knob. Ignore the fact that its on a autobox


knobs I make for the planes... Everything make on manual machines not a computer ;)

[MonkeyMadness]

Built my own M62 V8 swap mounts...

[Vivek]

ive gone through 4 years of metal shop at my hs, and was hired full time ofr 2 years straight out of hs as a welder fabricator for a performance racing shop.

lets just say this is my favorite thread..

Damn, I wish I could take that class. I wouldn't mind doing work like this, at least for a couple years in college. Seems like a ton of fun and you can make a lot of expensive parts for free.

[!kid]

[!kid]

my diff almsot fell out while at a local track during drift practice. two bolts jumped ship, another ripped out as you can see. and the last one was loose but still hanging on. :???: i got all new bolts 5mm longer and used blue loctite on all of them!

[Nsquared97]

Manufacturing an unmistakable trademark: the Porsche Crest