If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
No idea on cost. But there are lots of plastic manufacturers around the country. I have used ridout plastics for custom plastic pieces for electronics before.
i sent a couple emails to guys on ebay who custom cut king starboard, figured i'd give someone on r3v the business if possible. i'll look into that rideout place.
Not compared to aluminum. While they would work, they would deteriorate, and unless you kept an eye on them, could cause problems. I bet they would cause the wheel bolts to loosen due to expanding/contacting due to temperature.
Comment