Announcement

Collapse
No announcement yet.

Help Diagnose fault codes

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Help Diagnose fault codes

    I bought another E30. I was getting tired of looking at Sandy's destruction to my old E30. I picked this car up in Pittsburgh. I put Lucas full gas treatment and 91 octane in gas tank for the 6 hour drive home. Car may have sat for 6 months. I am having a stalling/wanting to shut off issue while driving. Check engine comes on at the same time then goes off.

    I ran a diagnostic today for faulty codes.
    22 idle actuator zwd winding 2, 51 transmission intervention, 53 full load swtich, 5 tank venting system, 16 and 17 for injector valves and 3 for fuel pump relay.

    I changed oil cap (crack), fuel pressure regulator hose (dry rot), new fuel filter and injector cleaner yesterday. Also, I had to put two new transmission mounts in. There was no rubeer just metal to metal. I ordered new spark plugs, crank sensor and temp sensor. I am going to clean the throttle body, mass air flow and idle control valve. Any suggestions? I have a Bentley but can not put my hands on it now.
    Last edited by GT BMW E30; 12-15-2012, 07:59 AM.

    #2
    There is something about this pic!!!!!! So 80's



    more pics

    http://s773.photobucket.com/albums/y...e%20II%20vert/
    Last edited by GT BMW E30; 12-15-2012, 09:16 AM. Reason: wrong information

    Comment


      #3
      Here is pictures of diagnostic reading. Can someone pin point the cause from this or narrow it down? I did notice mixture in fuel changed form rich to lean.
















      Comment

      Working...
      X