ebay suspension refresh kit???

[e30 vert]

what do you guys think about this refresh kit on ebay ?

http://www.ebay.com/itm/NEW-BMW-E30-...e4e00c&vxp=mtr


http://www.ebay.com/itm/BMW-E30-318-...fde363&vxp=mtr

[Tisoc]

Hmm, seems like top shelf stuff.... No seriously, if you plan on keeping the car, I would steer clear.

[blunttech]

If youre on a budget buy one decent suspension piece each payday and stick them in your garage until you have a full set. Too much labor and alignment costs involved to run that stuff

[e30 vert]

so should i go with oem from stealership?

[TimbyMaTombo]

Go with the refresh kit from Blunt. I have one sitting in my room. I still need to install it but it's top notch and dude's awesome to work with!

[Threehz]

Avoid those, save yourself the pain.

Check out blunttech.com or pelicanparts.com. Parts will cost a little more than the Ebay kits but they are well worth it.

[CHIF8008]

orr look up BMA we r3vers get a 5% discount if you use the code

[amcink]

what do you guys think about this refresh kit on ebay ?

http://www.ebay.com/itm/NEW-BMW-E30-...e4e00c&vxp=mtr


http://www.ebay.com/itm/BMW-E30-318-...fde363&vxp=mtr

I recently installed the 142 and it is working fine. About 300 miles now

[K1CKBAC]

300 miles is too early to determine whether it's good or not. Like others said, go with stuff from Blunt.

[graveshaker]

http://www.fcpeuro.com/BMW-parts/318...991&m=20&e=175

[e30trooper]

I just bought all of the same parts you listed, but from pelican. Spent about 300 shipped.

[Andy348]

I did a lot of searching when I needed to do my control arms and found that lots of people had bad experiences with eBay control arms. A couple of people even had them break off while driving!

www.blunttech.com <- order there

[e30 vert]

Go with the refresh kit from Blunt. I have one sitting in my room. I still need to install it but it's top notch and dude's awesome to work with!

thanks for your info

[e30 vert]

thanks every one for the help

[e30 vert]

how about getting a good quality bushing and ball joint and have the shop to put on the control arm ?